Proper Water Pump Start-Up Instructions

Place the pump in water first

Fully submerge the water pump in water and leave it underwater for 3–5 minutes.

Plug in the pump

After soaking, connect the pump to a compatible low-power plug.

Check water flow

Once powered, the water should start flowing normally.

If the pump is not working even after following all the necessary steps, kindly reach out to us at info@get-selene.com so we may further assist you.

Tip: Never run the pump in open air, as this can trap air inside and lead to performance issues or pump failure.

The information provided on this site is not intended as a substitute for professional veterinary or medical advice. Selene products are not designed to diagnose, treat, cure, or prevent any disease. If your pet has, or you suspect your pet may have, a medical condition, please consult a licensed veterinarian immediately. Only a qualified veterinarian can diagnose medical conditions.

These statements have not been evaluated by the Food and Drug Administration. Results may vary. Not intended for human consumption. Always consult your veterinarian before making any changes to your pet’s treatment or supplementation.

Your cart is empty

Your cart0

Proper Water Pump Start-Up Instructions

Place the pump in water first

Plug in the pump

Check water flow

Country/region

Country/region

Proper Water Pump Start-Up Instructions

Place the pump in water first

Plug in the pump

Check water flow

Join the VIP dog club